LATEST VERSIONS

If you would like to be e-mailed when new products and updates become available then click here to join our mailing list. We promise you will not be swamped by hundreds of e-mails as we appreciate that your time should not be wasted (also we do not have time to write them). We will never pass on your details to any other party (unless legally bound to do so).

The current release versions of our software and firmware are as follows:

Texture Expert Exceed 2.64

Contact your local Stable Micro Systems distributor for pricing information of new packages and upgrades from XTRA Dimension or Texture Expert 1.xx.

Some of the new facilities in Texture Expert Exceed require the latest Firmware.

Please ensure you confirm with your distributor that your Texture Analyser can accept the latest EPROM if you are relying on these new facilities.

The Latest Versions of our Firmware are:

7.16, 6.16 or 5.20 depending on the CPU board revision in the Texture Analyser or Materials Tester

Version 7.xx and 6.xx drive different hardware and are updated in parallel so they are identical as far as features and operation are concerned. Therefore it is not necessary to upgrade from version 6.xx to version 7.xx.

The table below shows which firmware version will work with which keyboard PCB revision.

Keyboard Revision	Firmware Version
A to E	5.xx
F to J	6.xx
K	7.xx

The Keyboard Revision information ('Rev' code) is printed on the Texture Analyser Keyboard Printed Circuit Board. You will have to turn the keyboard upside down, remove the five screws and separate the case to view this. The 'Rev' code is located on the bottom - left corner.

Contact your local dealer or Stable Micro Systems for more information. Make sure you know the Keyboard PCB 'Rev' code.

The Latest Version of our Windows^tm Software Texture Expert is 1.22

If you have an earlier version of Texture Expert and you would like an update to the latest version then you can download the patch files from this site.

If you wish to upgrade from Texture Expert to Texture Expert Exceed please contact us or your local dealer for information about pricing.

The Latest Version of our Windows^tm Software D_R_DIS is 1.05

If you have an earlier version of the D_R_DIS software and you would like an upgrade to the latest version then please contact us or your local dealer with your details. On receiving your details we will respond quickly with your upgrade. This software package is for use only with the Dobraszczyk Roberts Dough Inflation System.

The Latest Version of our Windows^tm Software Materials Master (Materials Test) is 1.20

If you have an earlier version of Materials Master and you would like an upgrade to the latest version of Materials Master then you can download the patch files from this site.

The Latest Version of our DOS Software XTRA Dimension is 3.7L

If you have an earlier version of XTRA Dimension and you would like an upgrade to the latest version then you can download the patch files from this site. You will also need to ensure that your Texture Analyser has a firmware version greater than 5.16 but less than 6.0. If you need the firmware updated then email tech.support@stablemicrosystems.com and include the serial number of the TA and your full mailing address so we can send the EPROM to you.
 
If you wish to upgrade from the XTRA Dimension package to Texture Expert or Texture Expert Exceed please contact us or your local dealer for information about pricing.

The Latest Version of our DOS Software XTRA Dimension 2 (Materials Test) is 1.12

If you have an earlier version of XTRA Dimension 2 and you would like an upgrade to the latest version then you can download the patch files from this site.
 
If you wish to upgrade from the XTRA Dimension 2 package to Materials Master please contact us or your local dealer for information about pricing.

For further information on our products please do not hesitate to contact us or your local dealer.